Lost Mary Tappo Pro Pod Kit

The Lost Mary Tappo Pro is the slim pen-style rechargeable kit on the Tappo pod platform. It pairs a 750mAh built-in battery with a 2ml prefilled pod, rated for up to approximately 600 puffs at 20mg nic salt. Shoppers also search for it as the Tappo Pro vape, the Tappo Pro pod kit, and the common misspell Tappi.

The 2ml pod clicks on through a magnetic top connector that is shared with the original Lost Mary Tappo, the ELFA Pro and the Elf Bar 600 V2. That makes this the most cross-compatible pen-style kit Lost Mary stocks. Pods from any of the three ranges click straight on without changing the kit body.

Charging runs over USB-C in approximately 50 minutes from empty. The draw is inhale activated with no buttons, no screen and no menu, sitting between MTL and a loose mouth-to-lung pull. The wider Lost Mary vape range covers the rest of the brand's prefilled and refill lineup.

Key Features at a Glance

• Cross-Platform Pod Fit - takes Tappo, ELFA Pro and Elf Bar 600 V2 pods on one kit body
• Magnetic Pod Connector - shared platform across Tappo, ELFA Pro and Elf Bar 600 V2
• 750mAh Built-In Battery - approximately 50-minute USB-C charge from empty
• 2ml Prefilled Pod - up to approximately 600 puffs at 20mg nic salt
• QUAQ Mesh Coil - sealed inside every pod, no coil install
• Slim Pen-Style Body - four colourways matched to a popular flavour pod
• Inhale Activated - no buttons, no screen, no menu

The Magnetic Pod Connector and Cross-Compatibility

The defining feature on the Tappo Pro is the magnetic pod connector at the top of the kit body. The same 2ml pod platform clicks into three other ranges, so a single kit unlocks three pod libraries from one device.

Pods from the original Lost Mary Tappo, the ELFA Pro and the Elf Bar 600 V2 all click straight on. Every compatible pod is a 2ml sealed unit at 20mg nic salt with a QUAQ mesh coil already inside. No adaptor, no re-fit, no setting change is needed.

Cross-fit is limited to that shared platform. Pods from the BM600, BM6000, Nera 30K, Pro Max 7000 and Hawcos Crystal Pro all run dedicated Lost Mary platforms and will not click on. Anything from a different brand, such as a Vaporesso XROS or OXVA Xlim pod, will not fit either.

The QUAQ Mesh Coil and the 2ml Prefilled Pod

Each 2ml prefilled pod comes pre-loaded with 20mg Lost Mary nic salt and a sealed QUAQ mesh coil. The coil is built into the pod and is not user-replaceable, so there is no coil to thread or prime by hand.

A single pod is rated for up to approximately 600 puffs before the e-liquid runs dry, in line with UK regulations on 2ml prefilled pods. Actual pod life varies with draw style and how often the kit is used.

When a pod is spent, it pulls off the magnetic connector and a fresh one clicks on. A burnt taste before the rated puff window is usually a low e-liquid signal, and a pod swap restores full flavour. Refills are sold separately from the Lost Mary Tappo refill pod range.

The 750mAh Battery and 50-Minute USB-C Charge

The 750mAh built-in cell sits at the top end for a Lost Mary pen-style pod kit. It charges through a USB Type-C port on the base of the kit body. A full top-up from empty takes around 50 minutes on a 5V/2A wall adaptor.

An LED next to the charge port shows status throughout the cycle. Cable quality and wall adaptor output both affect the figure, so a low-amp port will charge slower. A standard USB-C cable is not included in the pack.

In day-to-day use the battery outlasts a single 2ml pod, so most vapers top up at pod-swap rather than mid-pod. At end-of-life, the cell is removable for recycling through any UK WEEE point or vape retailer with battery recycling.

Setting Up the Tappo Pro

1. Open the box and lift out the kit body and the prefilled pod.
2. Pull the silicone plug off the mouthpiece of the pod.
3. Peel any protective stickers off the base of the kit body.
4. Click the pod onto the top of the kit body. The magnetic connector pulls it into place.
5. Wait 30 to 60 seconds for the QUAQ mesh coil to soak the nic salt e-liquid.
6. Draw on the mouthpiece to vape. Firing is inhale activated, so there is no fire button.
7. Charge through the USB-C port on the base when the LED flashes low.

The first pod is included in the kit, so the Tappo Pro is ready to vape straight out of the pack. No coil install, no menu, no settings to adjust.

Lost Mary Tappo Pro Flavours

Four colourways come paired with a starter flavour pod: Strawberry Ice, Blueberry Sour Raspberry, Lemon and Lime, and Watermelon. Every pod runs at 20mg Lost Mary nic salt with the same QUAQ mesh coil.

The wider Tappo platform stocks 20-plus flavours across fruit, ice, menthol and tropical profiles, with refills sold in 2-pack pairs. Tap any flavour below to add to basket, or see the full lineup on the Lost Mary Tappo refill pod range.

[FLAVOURS_SECTION]

Troubleshooting the Tappo Pro

Three signals come up most often during normal use, and each has a quick fix to try before reaching out to Lost Mary support.

How long should a Lost Mary Tappo pod last

A 2ml Tappo pod is rated for up to approximately 600 puffs at 20mg nic salt. In day-to-day use, a heavy vaper will go through a pod in one or two days. A lighter draw style can stretch a pod across three to four days.

A burnt taste before the e-liquid is fully gone usually means the pod is near end-of-life. Pull the pod off the magnetic connector and click a fresh one on.

Which pods are compatible with the kit

The native pod is the Lost Mary Tappo refill. The kit also accepts ELFA Pro pods and Elf Bar 600 V2 pods through the same magnetic connector. Every compatible pod is a 2ml sealed unit at 20mg nic salt with a QUAQ mesh coil.

Other Lost Mary kits run dedicated pod platforms. BM600, BM6000, Nera 30K, Pro Max 7000 and Hawcos Crystal Pro pods will not click on.

How to charge the kit

Plug a USB-C cable into the port on the base of the kit body. Any standard USB-C cable works, including the type used on most current Android phones.

A full charge from empty takes around 50 minutes on a 5V/2A wall adaptor. The LED next to the port shows charging status, and the cable is not included in the pack.

Lost Mary Tappo Pro Specifications

What's in the Box

• 1 x Lost Mary Tappo Pro kit body (750mAh built-in rechargeable battery, LED indicator)
• 1 x 2ml prefilled pod with QUAQ mesh coil (chosen flavour, 20mg nic salt)
• 1 x User manual
• USB-C cable not included