Lost Mary BM600 Prefilled Pod Vape Kit

The Lost Mary BM600 is the rechargeable prefilled pod kit that replaced the original 600-puff disposable after the June 2025 UK ban. The kit pairs a 750mAh USB-C battery with a 2ml MaryLiq prefilled pod for approximately 600 puffs per pod. Shoppers also search for it as the BM 600, Lost Mary 600 and rechargeable Lost Mary 600.

Each pod is fixed at 20mg Lost Mary nic salt with a 0.8 ohm mesh coil and a 50/50 VG/PG blend. The kit body is inhale activated, so there is no fire button to hold. A single LED on the front reports battery status on every draw.

Pods are not refillable. When the e-liquid runs dry, the whole pod is swapped for a fresh one from the BM600 refill pod range. The wider Lost Mary vape range covers the rest of the brand's prefilled lineup.

Key Features at a Glance

• Direct Replacement for the 600 Disposable - same draw, now rechargeable
• 750mAh USB-C Battery - lasts a full day for most vapers
• 2ml MaryLiq Prefilled Pod - approximately 600 puffs per pod
• 20mg Nic Salt Only - fixed strength, MaryLiq formula
• 0.8 Ohm Mesh Coil - tight MTL draw for a smooth throat hit
• Single LED Status Light - battery level signalled on every draw

The Rechargeable BM600 Explained

The BM600 is the rechargeable answer to the original 600-puff Lost Mary disposable. The kit body holds a 750mAh internal battery that recharges over USB-C at the base.

Each prefilled pod still delivers approximately 600 puffs, the same figure as the original disposable. The difference is what happens at the end of the pod. Instead of the whole device going in the bin, the spent pod clicks out and a fresh one clicks in. The kit body stays.

That makes the BM600 the cheapest entry point into the Lost Mary rechargeable lineup. The draw, the flavour profile and the puff count match the disposable many vapers were already using before the single-use ban.

2ml MaryLiq Prefilled Pod and Mesh Coil

Each prefilled pod holds 2ml of MaryLiq e-liquid at 20mg nic salt, the UK TPD limit for prefilled pods. The pods are sealed at the factory and clip onto the top of the kit body with a magnetic connection.

Inside each pod is a 0.8 ohm mesh coil tuned for a tight MTL draw. The mesh design heats the e-liquid evenly across the surface, so the flavour stays consistent from the first puff to the last.

The pods are not refillable. When the pod runs dry, swap it for any flavour from the BM600 refill pod range. The kit body is fully compatible with every BM600 pod flavour.

LED Battery Indicator and USB-C Charging

A single LED sits on the front of the kit. It glows briefly on every draw to signal the battery level, and stays lit while the kit is on charge.

Three colours cover the full battery range. White means the battery is above 60%, blue means between 30% and 60%, and red means below 30% and a recharge is due. Plug the supplied USB-C cable into the base to top up.

A full charge from empty takes around 45 to 60 minutes on a standard 2A wall adaptor. The LED stays solid red while charging and switches off when the kit is full. Most vapers get through a full pod on a single charge.

Setting Up Your BM600

1. Unbox the kit body and the prefilled pod.
2. Peel the silicone plug off the base of the pod.
3. Click the pod onto the top of the kit body until it seats flush.
4. Charge the kit to full over USB-C before the first session.
5. Wait 30 to 60 seconds for the mesh coil to soak.
6. Inhale to vape. The LED glows on every draw to signal battery level.

Firing is inhale activated, so there is no button to hold. The kit goes to sleep automatically after each draw to save battery.

Lost Mary BM600 Flavours

The kit is sold with the chosen flavour pod fitted. Every pod is 20mg MaryLiq with the same 0.8 ohm mesh coil. Tap any flavour below to add to basket, or see the full lineup on the BM600 refill pod range.

[FLAVOURS_SECTION]

Troubleshooting the BM600

Three signals come up most often during normal use. Each has a quick fix to run before contacting Lost Mary support.

Red LED on the BM600

A solid red light during a draw means the battery has dropped below 30%. Plug a USB-C cable into the base of the kit and charge until the LED switches off, which signals a full top-up. A full charge from empty takes around 45 to 60 minutes on a standard 2A wall adaptor.

Flashing LED on the BM600

A rapid flash usually means the pod is not seated properly. Pull the pod off the kit body, wipe the base contacts with a dry tissue, then push it back on until it clicks home. Three or four flashes can also signal a short circuit, which clears once a fresh pod is fitted.

How to charge the Lost Mary BM600

Charge the kit through the USB-C port at the base of the body. Plug into a 2A wall adaptor or a powered USB port, and the LED will stay solid red while charging.

When the LED switches off, the kit is fully charged and ready to unplug. Most vapers get through a full 2ml pod on a single charge, depending on draw style.

Lost Mary BM600 Specifications

What's in the Box

• 1 x Lost Mary BM600 kit body (750mAh rechargeable battery, single LED indicator)
• 1 x 2ml MaryLiq prefilled pod with 0.8 ohm mesh coil (chosen flavour, 20mg nic salt)
• 1 x USB-C charging cable
• 1 x User manual